- Input voltage 220÷240 Vac, 50÷60 Hz
- Output voltage 13.8 V / 14.4 V
- Nominal 12 V (mode 12 Volt)
- Charging current 0.9 A max
- Battery types 12 V lead-acid
- (wet batteries, gel, maintenance-free, VRLA, AGM, Ca/Ca, etc.) & 12V LiFePO4)
- Charging algorithm - lead-acid 8 automatic charging stages
- (initialization, recovery, light charge, bulk charge, desulfation, battery analysis, maintenance, equalization)
- Battery capacity - LiFePO4 from 1 Ah to 100 Ah
- Operating temperature From -20° to +50°C
- IP protection class Weatherproof - splash protection IP44
- Suitable for outdoor use
The BC K900 EVO+ is a charger and maintenance device for all 12V lead-acid and lithium batteries and is also CAN-bus compatible, e.g. BMW motorcycles. It is ideal for restoring, charging and maintaining all scooter, ATV and motorcycle batteries and can also be used for car battery maintenance. The device can always remain connected to the battery as long as the vehicle is not in use. Simple mode selection, just press one button. 3 LEDs show the operating mode used, which is stored in memory for later use. The BC K900 EVO+ carries out an automatic microprocessor-controlled multi-cycle charging process (8 cycles for lead-acid batteries, 7 cycles for LiFePO4 batteries). The charging technology for lead-acid batteries is ideal for recharging deeply discharged batteries, provided there is no cell defect yet. Desulfation and maintenance of all 12V batteries up to 100 Ah. At low temperatures, which are detected by an integrated sensor, the POLAR mode is automatically activated. The device delivers a maximum current of 0.9 amps. Two LEDs show the current status as well as error messages. BC K900 EVO+ does not produce sparks and is protected against short circuits, reverse polarity, overvoltage and overheating. The packaging includes a waterproof cable with eyelets that can always remain mounted on the vehicle. The warranty period is 3 years.
